Neck facing pattern

Create a neck facing pattern from your neckline

Generate front and back neckline facings with seam allowance, center-fold guides, shoulder notches, and print-ready exports. Use the finished neckline from a bodice or dress, or enter front and back neckline lengths manually.

Open neck facing builder All templates

Neck facing preview

Related guides

Generator

Basic bodice pattern

Draft a bodice block with neckline, armhole, shoulder, length, and waist shaping.

Generator

Basic dress pattern

Build a connected bodice and skirt draft with waist, darts, length, and hem checks.

Detail

Collar pattern

Generate a shirt collar, stand collar, or flat collar matched to the neckline.

Neck facing guide

Printable facings matched to the neckline seam

The generator drafts separate front and back facing half-patterns on fold. The inner facing curves are fitted to the front and back neckline seam lengths, while the outer curves create a stable finishing width for clean sewing.

Included

Front and back facings

The export includes front and back facing pieces, inner neckline seam curves, outer facing curves, dashed seam allowance, center-fold lines, shoulder notches, labels, and a 5 × 5 cm test square.

Measurements

Front and back neckline lengths

Use the finished neckline seam lengths from the garment, not body neck circumference. When started from a basic bodice or dress, these values are filled from the generated geometry.

Construction

Facing width and seam allowance

Facing width controls how deep the internal finish sits inside the garment. Seam allowance is added as a cutting guide around the facing pieces.

Compatibility

Match before cutting

Compare the facing inner curves with the prepared neckline and test the shoulder join before cutting final fabric or interfacing.

Printing

A4 tiled PDF, copyshop PDF or SVG

Print at actual size or 100%, disable page scaling, and verify the 5 × 5 cm square before cutting.

Common questions

Neck facing pattern FAQ

Is a neck facing different from a collar?

Yes. A neck facing finishes the neckline on the inside of the garment, while a collar is a visible external piece attached to the neckline.

Should I use total neckline length?

The generator can show the total length, but the draft uses separate front and back neckline lengths so each facing piece matches its garment section.

Can I start from a bodice or dress?

Yes. Basic bodice and dress previews pass the calculated front and back neckline lengths directly into this generator.

What facing width should I use?

A standard 4–6 cm facing is suitable for many woven garments. Use a narrower facing for lightweight styles and a deeper facing when the neckline needs more stability.

How should I print the A4 neck facing?

Print at actual size or 100%, disable fit-to-page scaling, and check the 5 × 5 cm test square before cutting fabric.

Workflow

Use the neckline

Start from the finished front and back neckline lengths, either manually or from a generated bodice or dress.

Choose facing width

Select standard, narrow, or deeper facing width and seam allowance.

Export for print

Download SVG, copyshop PDF, or tiled A4 PDF with test square and construction marks.